Two employees were attending to a fault on the raw material bucket elevator. During the task, one employee was using a hammer to drive a securing pin back into position to secure the elevator’s bottom chute. While striking the pin, the employee misjudged the hammer blow and struck a finger against the steelwork. The employee immediately informed the operations manager of the incident and was advised to attend A&E for assessment. Later that evening, the employee confirmed that the injury had resulted in a fractured fingertip.
KEY FINDINGS
- Permit to Work was completed for the task.
- An initial risk assessment had been completed by both employees.
- Isolation was carried out correctly.
- The job scope had changed, therefore the initial risk assessment should have been reviewed to identify the additional hazards (using a hammer).
- SSOW did not fully identify the steps required to complete the task without the need for a hammer.
- Gloves were being worn at the time of the incident; however, they were not an impact-resistant type.
Image below is X-ray of the damaged finger
